One cable slipping off its drum groove is enough to jam a door mid-cycle or send a panel crashing at an angle. We fix the cable and check why it slipped in the first place.
When one lift cable fails, the other has seen the same wear cycle. We replace both to prevent a repeat call.
Cable replacement without a drum check is an incomplete repair, so we always look at both.
Our technicians are trained to safely release and reset tension when cables are involved, not just the springs.
We carry the common cable lengths and gauges for most residential door sizes.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
A snapped cable leaves the door hanging unevenly on the remaining side, an unsafe condition we treat as priority.
Fraying cable strands are a warning sign of imminent failure. We replace before it snaps and drops the door unexpectedly.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
We match new drums to the correct diameter for your door's cable length requirements.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Cable stock on the truck means most calls avoid a second trip for parts.
Diagnosis includes the drums, not just the visible cable, before any price is confirmed.
Cables replaced, tension balanced, and the door tested level before we leave, backed by written warranty.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Explained why replacing just one cable wasn't a real fix. Makes sense once you see the wear pattern.”
“Door was jamming mid-cycle for weeks. Cable and drum issue, fixed in one visit.”
This almost always means one lift cable or spring has failed while the other side is still holding weight.
Replacing just one often leads to a second failure soon after. We're upfront about that tradeoff.
This is a genuine safety hazard, especially with people or vehicles near the door opening.
Repeated slipping points to a drum issue rather than just the cable itself, which we'll inspect.
Pricing depends on cable length, gauge, and whether the drums also need replacing, confirmed as a flat number before work starts.
A snapped-cable call usually resolves in under two hours on-site.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Highland to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Highland, UT